Alpha Smartware EC-52010-06 Instrucciones De Instalación página 30

Display elements
7 Display elements
A B
LED Colour/
interval
All All constantly on (Four seconds)
Fuse Constantly on/All other LEDs off
Off
Clear Flashing
DEU
Pairing Flashes slowly
ENG
Flashes quickly
FRA
Power/Error Off
NDL
ITA
ESP
Lights up constantly green: Power
DAN Lights up constantly orange
NOR
Lights up constantly red: Error
FIN
Flashes slowly red
SWE
Flashes red quickly
POL
RUS
Flashes red/flashes green
Pump Constantly on
Heating Flashes per heating zone
zone 1...6
1...10
All light up after power supply (ten min-
utes)
Light up per heating zone
Lights up per heating zone/LED Pairing
flashes
Heating Flashes per heating zone: 1 Hz
zone 1...6
1...10
30
C D E
F
Description Remedy
Startup process active -
Fuse defective, power Determine the cause: wiring fault, short
supply active circuit of an actuator, possible overvoltage
event. After that: Change the fuse [} 31]
Fuse OK -
Unpairing a room control Cancel the pairing process or cancel
unit process with the button Clear
Pairing mode enabled -
Waiting for signal from Assign heating zones or cancel the process
the room control unit with the key Clear
Voltage supply inter-
rupted or defective.
Power supply active -
Startup process active -
Error active. Device de- Perform factory reset / have device
fective checked by electrician
Ready for factory reset Repeat the pairing process or cancel with
button Clear
Error during pairing Repeat the pairing process or cancel with
process or reset process button Clear
started
Error during update
process
Pump control or pump -
protection function active
Pairing mode for room Perform pairing process or cancel with key
control unit active Clear
Triggering of all heating
zones one after the
other: First Open function
is active
Heating zone active/cou- -
pled with room control
unit
Heating zone free for Perform pairing process for free heating
pairing zones where the heating zone LED is flash-
ing or cancel with key Clear
Heating zone in emer-
gency operation Protec-
tion functions [} 22]
– Check connections between power
supply unit and base station.
– Check the power supply of the socket
– Renew device if necessary
– Check batteries on the room control
unit