Publicidad
Idiomas disponibles
Idiomas disponibles
Audio Settings
Audio Settings
<Fader/Balance>
J
K
H
I
Touch [
]/[
]/[
]/[
] or drag the
<Fader>
When <X'over Network> is set to [2 way], you can
adjust the front and rear speaker output balance.
• F15 to R15 (Initial: 0)
<Balance>
Adjusts the left and right speaker output balance.
• L15 to R15 (Initial: 0)
To clear the adjustment: Touch [Center].
Other Information
Other Information
For playback operations of SiriusXM® Radio
sources and other settings information, refer to the
mark to adjust.
INSTRUCTION MANUAL on the following website:
<https://www.kenwood.com/cs/ce/>
• The availability of each source vary depending on
the model.
Note for specifications
Bluetooth Frequency Range:
2.402 GHz — 2.480 GHz
Speaker Impedance:
4 Ω — 8 Ω
Operating Voltage:
12 V DC car battery
Installation and Connection
Installation and Connection
This section is for the professional installer.
For safety's sake, leave wiring and mounting to
professionals. Consult the car audio dealer.
WARNINGS
• DO NOT connect the ignition wire (red) and the
battery wire (yellow) to the car chassis (ground), you
may cause a short circuit, that in turn may start a fire.
• DO NOT cut out the fuse from the ignition wire (red)
and the battery wire (yellow). The power supply must
be connected to the wires via the fuse.
• Always connect the ignition wire (red) and the
battery wire (yellow) to the power source running
through the fuse box.
CAUTIONS
• Install this unit in the console of your car.
• Do not touch the metal parts of this unit during and
shortly after the use of the unit. Metal parts such as
the heat sink and enclosure become hot.
• When parking at a low ceiling area, turn off the unit
to store the antenna. As when the unit is installed in
the car with the function of auto antenna; the radio
antenna extends automatically when you turn on
the unit with the antenna control wire (ANT. CONT)
connected (page 32).
ENGLISH
27
Publicidad
