Ameda Platinum Instrucciones página 7

eed suction timer
suction
speed
suction timer
speed suctio
Removing Ameda HygieniKit Milk Collection System from Breast(s)
• After pump is OFF, if necessary, insert a finger between breast(s) and breast flanges(s) to break suction.
• Remove breast flanges(s) from breast(s).
• Place bottles with milk in bottle holders.
Setting Suction
• Pump starts at lowest suction setting (1% or approximately 30mmHg /4 .0kPa).
• Center nipple(s) in breast flange(s) and fill breast flange(s) with the breast(s) to create
an air seal. Keep upper body and bottles/flanges upright while pumping.
• Press to increase suction until reaching maximum comfort level.
• If discomfort is felt in nipple(s) or breast(s), press
is felt at all suction settings, turn pump off, insert a finger between breast(s) and breast
flange(s) to break suction, remove breast flange(s) from breast(s). Discontinue
pumping and contact a healthcare provider.
Setting Speed
• Pump starts at fastest speed (80 cpm).
• When milk flows (let-down), press
faster .
• When milk flow slows, press
another let-down .
• Repeat as milk flow changes to pump more milk.
NOTE: If "Check Kit" appears in suction window, see Troubleshooting section, on page 8.
Using Timer
• Timer starts when pump is on. Timer displays pumping duration in minutes : seconds.
• Timer can be reset by pressing Timer Reset
• Timer and pump automatically turn OFF after 60 minutes.
Turning Pump OFF
• When finished pumping, press and hold Power
functions OFF.
to decrease suction. If discomfort
to decrease speed to help drain the breast
to increase speed to 60-80 cpm to help start
button.
button to turn pump and timer
ENGLISH | 7