Whirlpool W6 OS4 4S1 H BL Guía Rápida página 6

6. END OF COOKING
An audible signal will sound and the display will
indicate that cooking is complete.
END
Press to continue cooking in manual mode (untimed)
or press to extend the cooking time by setting a new
duration. In both cases, the cooking parameters will be
retained. Once the food has been removed, leave the
oven cooling down with the door closed.
BROWNING
Some functions of the oven enable you to brown the
surface of the food by activating the grill once cooking
is complete.
PRESS v TO BROWN
When the display shows the relevant message, if
required press to start a five-minute browning cycle.
You can stop the function at any time by pressing
switch the oven off.
. FAVORITES
Once cooking is complete the display will prompt you
to save the function in a number between 1 and 10 on
your list of favorites.
ADD FAVORITE?
If you would like to save a function as a favorite and
store the current settings for future use, press
otherwise, to ignore the request press
Once has been pressed, press the
number position, then press
Please note: If the memory is full or the number chosen has
already been taken, the oven will ask you to confirm
overwriting the previous function.
To call up the functions you have saved at a later time,
press : The display will show your list of favorite
functions.
1. CONVENTIONAL
Press or to select the function, confirm by pressing
, and then press
CLEANING
• SMARTCLEAN
Press to show "Smart Clean" on the display.
Smart clean
Press to activate the function: the display will
6
.
or to select the
to confirm.
to activate.
prompt you to do all actions needed to obtain the
best cleaning results: Follow the indications and then
press when done. Once you have done all steps,
when required press
Please note: It is reccommended to do not open the oven
door during the cleaning cycle to avoid a loss of water vapor
that could get an adverse effect on the final cleaning result.
An appropriate message will start flashing on the
display once the cycle has finished. Leave the oven to
cool and then wipe and dry the interior surfaces with
a cloth or sponge.
•
DRAIN
The drain function allows the water to be drained in
order to prevent stagnation in the tank. For optimal use
of the appliance, it is advisable to always carry out
draining everytime the oven has been used with a
steam cycle.
to
average duration for full load drainage is about three
minutes.
If needed, it is possible to pause the draining process by
pressing BACK or STOP button (for example in case the
jug would be already full of water in the middle of the
draining process).
The jug must be at least 2 liters large.
Please note: to ensure that the water is cold, it is not possible
to perform this activity before 4 hours have elapsed from the
last cycle (or the last time the product was powered). During
this waiting time, the display will show the following feedback
"WATER IS HOT - PLEASE WAIT".
• DESCALE
This special function, activated at regular intervals,
allows you to keep the tank and the steam circuit in the
best condition.
The message <PLEASE DESCALE> will be shown
on display, to remind you to execute this operation
regularly.
Descale requirement is triggered by the number of
steam cooking cycles performed or steam boiler
working hours since the last descale cycle (see the table
below).
"PLEASE DESCALE" MESSAGE appears
after
15 cycles of steam cooking
22 hours of steam cooking duration
20 cycles of steam cooking
30 hours of steam cooking duration
to activate the cleaning cycle.
Once selected the "Drain"
function, press and follow
the actions indicated: Open
the door and place a large jug
under the drain nozzle located
at the bottom right of the panel.
Once started the draining, keep
the jug in position until the
operation is completed. The
WHAT TO DO
Descale is recommended
It is not possible to run a
Steam cycle until a Descale
cycle will be carried out