STERWINS EGT2-25.4 Manual Del Usuario página 175

Idiomas disponibles

The declared vibration total value has been measured in accordance with a standard test

method and may be used for comparing one tool with another. The declared vibration total

value may also be used in a preliminary exposure assessment. The vibration emission during

actual use of the power tool can differ from the declared total value depending on the ways

in which the tool is used; and it may be necessary to identify safety measures to protect the

operator that are based on an estimation of exposure in the actual conditions of use (taking

into account all parts of the operating cycle such as the times when the tool is switched off and

when it is running idle in addition to the trigger time).

3. ASSEMBLY

WARNING! THE PRODUCT MUST BE FULLY ASSEMBLED BEFORE

OPERATION! DO NOT USE A PRODUCT THAT IS ONLY PARTLY

ASSEMBLED OR ASSEMBLED WITH DAMAGED PARTS! FOLLOW

THE ASSEMBLY INSTRUCTIONS STEP-BY-STEP AND USE THE

PICTURES PROVIDED AS A VISUAL GUIDE TO EASILY ASSEMBLE

THE PRODUCT !

3.1 UNBOXING

• Wear gloves when unboxing.

• Do not use cutter, knife, saw or any other similar tool for unboxing.

• Carry the tool only by the handle (7).

3.2 INSTALLATION

Assemble the shaft: illustration 2.1

Join the three shafts and install the screw with a screw driver. Tighten the screw securely.

Adjusting the auxiliary handle: illustration 2.2 and 2.3

Loosen the bolt and washer on the auxiliary handle. Attach the auxiliary handle to the ﬁxed seat

on the shaft with the knob component. Adjust the handle to a suitable position for you. Tighten

175

1. Spool set

2. Spool guard

3. Motor housing

4. Tube

5. Auxiliary handle

6. Handle knob

7. Rear handle

8. Switch trigger

• Keep the box for further reuse (transport and storage).

• Keep instruction manual in a dry area for further consultation.