STERWINS EGT2-25.4 Manual Del Usuario página 177

Idiomas disponibles

3.5 OPERATION & CUTTING TIPS

WARNING : DO NOT INSERT OR DISCONNECT THE POWER PLUG

WHILE THE TRIGGER IS PRESSED OR WHILE THE POWER TOOL IS

IN MOTION.

CAUTION ! ALWAYS WEAR SAFETY GLASSES. WEAR A FILTER

MASK IF THE OPERATION IS DUSTY. USE OF PROPER GLOVES AND

SUBSTANTIAL FOOTWEAR IS ALSO RECOMMENDED.

Switching on/off : illustration 4.1 to 4.2

Connect the cable to the power. To switch on, keep the switch trigger depressed. To switch off,

release the switch trigger. WARNING! The tool runs for approximately 5 seconds after it has

been switched off. Let the motor came to a complete stand still before setting the tool down.

NOTE: This appliance has a cutting wire automatic feed head. Do not strike the cutter head on

the ground as this will damage the product.

NOTE: The cutting line will stretch approximately 8 mm at each stop and start until the line has

reached the length of the wire cutter. Avoid stopping and restarting the appliance frequently as

the cutting line will lengthen unnecessarily each time, wasting a large length of wire.

Cutting with the spool : illustration 4.3

Make sure that the work area is free of rock, debris, lines and other foreign objects. Start the

tool before approaching the grass to be cut. If you need to release the line, please press the

switch trigger. If too much line is fed out and it projects beyond the guard edge it is cut by the

line cutting blade. Cut the grass by swinging the tool from right to left and the tool inclined

forwards at an angle of about 30. Light cuts are better than heavy cuts as they allow the cut

grass to fall away from the spool preventing the grass from clogging the spool. Start cutting

nearest the mains power source and work away from it to make it easier to avoid the cable.

High grass should be cut in layers always beginning from the top. Do not cut damp or wet

grass. Do not overload your tool. Avoid wearing the line out quickly by knocking against hard

objects(stones, walls, fences etc). Watch out for kickbacks in the events of impact with hard

objects. After ﬁnishing the cutting operation, keep the head close to ground level,release the

switch and follow the motor to come to a complete standstill. Place the tool on the ground,

switch off and remove the cable plug from the main supply.

NOTE: TRIM LONGER GRASS IN STAGES; DO NOT CUT LONG GRASS

IN ONE CUT. FOR THE BEST RESULTS, CUT LONGER GRASS IN

STEPS.

Extending the line for spool set

To extend the line,press the switch trigger and the line will extend automatically. For most

effective grass trimming, ensure the machine is operation at full speed, and ensuring that you

do not overload the machine by cutting too fast or cutting through heavy terrain.

NOTE: Periodically clean out the grass between the spool and the rim of the guard to prevent

the tool from vibrating.

177