STERWINS EGT2-25.4 Manual Del Usuario página 176

Idiomas disponibles

the knob component securely.

Loosen the knob and slide the auxiliary handle up or downward to adjust the height to ﬁt the

intended application. Tighten the knob in the adjusted position. Ensure that the tooth system

locks in place.

NOTE: Ensure the connection is properly secured. Tighten the knob so far until there is not gap

between the handle and handle support.

Attaching the guard: illustration 2.4 and 2.5

1. Insert the spool guard to the power head.

2. Insert the screw through the spool guard and into the power head. Use the screw driver to

tighten the screw securely.

3. Remove the grass knife protective tap.

3.3 PREPARATION

Safety equipment and protective clothing : illustration 3.1

Make absolutely sure to wear the appropriate close-ﬁtting protective clothing such as protective

pants, gloves and safety shoes. Wear a safety helmet with integrated hearing protection and a

face guard. Do secure long hair so that it is above shoulder level.

Use the following safety clothing and protective equipment when operating the product:

- Hearing protectors

- Gloves with approved saw protection

- Protective overall

- Safety glasses

- First aid kit in case of injury.

Connecting to the mains: illustration 3.2

Fix the power line to the handle hook and connect plug to the mains.

3.4 FIRST USE

Pay particular attention using the machine for the ﬁrst time : focus and dedicate all your

attention to this ﬁrst use. Make the ﬁrst trial on a free space with no obstacle and no surrounding

element.

Before use, check that the trimmer in good working order ,as follows:

1. Ensure the switch is on the off position and disconnect the cable plug from the mains supply.

2. Examine the general condition of the tool. Inspect the guard and switch. Check for loose

screws, misalignment, and binding of moving parts, improper mounting, broken parts and any

other condition that may affect its safe operation. If abnormal noise or vibration occurs during

operation, turn machine off immediately and have the problem corrected .Do not use a damaged

tool and attach a label "DO NOT USE" to the tool.

3. Ensure that you are on a ﬂat surface and have secure footing.

WARNING ! READ THE « SAFETY INSTRUCTION » SECTION AT THE

BEGINNING OF THIS MANUAL INCLUDING ALL TEXT UNDER

SUBHEADING THEREIN BEFORE USING THIS PRODUCT.

176