Crux ARTISAN Serie Manual De Instrucciones página 7

BEFORE USING FOR THE FIRST TIME
The juice extractor comes almost completely assembled in the box.
1. Your extractor may be shipped with a protective cardboard insert between the clear cover
and the blade basket. Remove this and any other protective packaging before using your juice
extractor. Also included in the box is a cleaning brush.
2. Following the disassembly instructions, remove the food pusher from the feed tube, then the
cover, juice bowl with stainless steel blade basket.
3. Wash all removable parts (food pusher, clear cover, juice bowl, pulp basket, and juice jug with
lid) in warm water with a biodegradable, non-abrasive liquid detergent. Rinse well and air-dry.
This will eliminate any traces of dust or residue from manufacturing or shipping.
Caution: Use care when handling the blade basket. Hold the basket's rim only.
Do not touch the cutter blades on the bottom of the basket. The cutter blades are very sharp!
Caution: Never rinse or immerse the motor base in water or any other liquid.
ASSEMBLY INSTRUCTIONS
Warning: Always make sure the juice
extractor is unplugged before starting
assembly.
Important: The juice extractor is
equipped with a safety system that
prevents the extractor from being
turned on unless the unit is completely
and properly assembled.
1. Rotate the locking bar so that it
sits at the front of the base (see
figure 2).
2. Place the juice bowl on top of
the motor base so that the juice
spout fits into the cut out at the
front of the base (see figure 3).
Caution: Use care when handling
the stainless steel blade basket.
Hold the basket's rim only. Do
not touch the cutter blades
on the bottom of the basket.
The cutter blades are very sharp!
3. Set the stainless steel blade
basket onto the motor hub in
the center of the juice bowl (see
figure 3). Press down on the blade
basket's outer rim until it drops
into place and is securely seated.
Gently rotate the blade basket
to ensure that it turns freely.
If initially it fails to seat, this should slip it into place. Double check by pressing down on the rim
and spinning it again.
4. Align the cover so that the pulp cover fits over the back of the base. (see figure 4).
5. Turn the food pusher so that the groove in the side lines up with the tab in the feed tube. Insert
the food pusher into the feed tube (see figure 5). Store the food pusher in the feed tube of the
lid until the produce is ready to juice.
6. Push the safety locking bar up and over the lid. Make sure the lid is locked securely into place
(see figure 6).
7. Add the pulp basket (see figure 7). Tilt the pulp basket slightly so that the lip of the juice bowl
fits snugly over the inside of the pulp basket. Push the bottom of the pulp basket so that it rests
securely on its platform.
Important: To avoid spillage, make sure the pulp basket sits flush up against the base.
Note: To save cleaning time, line the pulp basket with a plastic grocery store produce bag.
Figure 2
Figure 3
Figure 4
5
Figure 5
Groove
Tab
Locking
bar
Figure 6
Figure 7