Kichler Arkwet Weather+ Manual De Instrucciones página 12

ATTACHING THE FAN BLADES
CAUTION: To reduce the risk of electric shock, disconnect the
electrical supply circuit to the fan before installing fan blades.
Step 1. Attach a blade to a blade bracket using the screws and rubber
washers provided. (Fig. 14)
Make sure the blade is straight when set on the blade bracket. Tighten
each mounting screw until the rubber washer is slightly compressed.
Repeat this procedure for each blade.
Step 2. Attach each blade assembly to the motor using the
"Pre-Installed" mounting screws in the blade bracket. (Fig 14)
INSTALLING THE MOUNTING PLATE
Step 1. Loosen the two screws on the mounting ring attached to the
motor shaft and "remove" and save the third screw. (Fig. 15)
Step 2. Place the key holes on the mounting plate over the 2 screws
previously loosened from the mounting ring, turn mounting plate until it
locks in place at the narrow section of the key holes. Secure by tightening
the 2 screws previously loosened and the one previously removed.
(Fig. 15)
12 | KICHLER.COM
Fig. 14
Mounting Ring
Mounting Plate
Fig. 15
Screws
Slot
Blades
Rubber Washers
Screws