Descargar Imprimir esta página

Infiniton GAS41RO Manual De Instrucciones página 35

Ocultar thumbs Ver también para GAS41RO:

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
1.
Remove the cooking grate, burner cover and flame spreader, and place the product upside down on
a padded mat.
2. Make sure that the ignition equipment and flame control equipment are not affected in this opera-
tion.
3. Stick the sponge on the edge around the bottom perimeter of the product. Do not leave gaps that
have not been sealed with the sponge along the entire perimeter.
Never seal the plate to the recess with silicone
Sealing the hob with silicone is not recommended, as if the
hob has to be removed, it will be very difficult to remove it
from the worktop and may even break the glass.
Infiniton is not responsible for any damage caused by
applying silicone, which would void the warranty.
(A) SEALING STRAP
(C) SCREW
Gas connection
This appliance must be installed and connected in accordance with the specific regulations of the
country where it is to be installed.
GLP Connection
Main gas pipe
Gasket
Hose inlet connector
Metal clamp
Lpg connection hose
1.
2. Carefully rotate the hotplate and then gently
3. On the underside of the hob, adjust the brac-
(B) SUPPORT
37
.
Position the bracket (B) by aligning it over the
screw holes. There is a set of screw holes for
each corner of the plate (H). Slightly tighten the
screw (C) towards the bracket (B), so that the
bracket locks onto the hob and you can adjust
the position.
insert it into the recess you have cut out.
kets to the appropriate position on the hob.
Then tighten the screws (C) to ensure that it is
secured in position.
NG Connection
English
Main gas pipe
Gasket
Nut
Natural gas
Connection hose
infiniton.es

Publicidad

loading