Descargar Imprimir esta página

Infiniton GAS41RO Manual De Instrucciones página 36

Ocultar thumbs Ver también para GAS41RO:

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
WARNING: Before starting any work on the gas installation, turn off the gas supply. Risk of explosion.
1. Connect the appliance to the gas tap from the shortest route and in a way that prevents leakage. For
safety reasons, the hose used must be a maximum of 125 cm and a minimum of 40 cm.
2. When checking for gas leaks, never use a match, lighted cigarette or similar flammable materials.
3. Apply bubble soap to the point of connection. If there is any leakage, bubbles/foam will form in the
soapy region.
4. If the table-top cooker is to be mounted in a cupboard or drawer that can be opened, a heat protec-
tion panel with a minimum opening of 15 mm must be mounted under the hotplate.
LPG connection
For the LPG (gas cylinder) connection, attach the metal clamp to the hose leading from the LPG cylinder.
Attach one end of the hose to the hose inlet connector behind the product by pushing the end of the
hose through the heat of the hose with boiling water.
Then place the hose clamp towards the end of the hose and tighten it with a screwdriver.
The gasket inlet connector and hose required for the connection are shown in the picture below.
NOTE: The regulator installed on the LPG cylinder must have the 300 mmSS characteristic.
Main gas pipe
Gasket
Hose inlet connector
Metal clamp
Lpg connection hose
NG Connection
WARNING: The natural gas connection must only be carried out by an authorised service technician.
For natural gas connection, place the gasket on the nut at the end of the natural gas connection hose.
To install the hose on the gas main, turn the nut. Complete the connection when you check for gas leaks.
Main gas pipe
Gasket
Nut
Natural gas
Connection hose
WARNING: The gas hose and the electrical connection of the product
must not pass near hot areas, e.g. the rear of the product.
The gas hose must be connected by turning it at an open angle to
prevent it from rupturing. If the product is moved while connected to the
gas, gas leakage may occur.
38
English
infiniton.es

Publicidad

loading