Publicidad
Idiomas disponibles
Idiomas disponibles
gradually.
•Once you have selected the desired cycle,
the corresponding LED will flash for 3
seconds and will become steadily lit,
enabling the selection.
•If you operate the knob that adjusts the
paddle speed, you will be able to adjust the
density of the preparation: to low speed
corresponds a higher density while at high
speed you will have an increased air intake
and a smaller density of the preparation. The
speed and selected cycle combination
makes it possible to obtain various
preservation cycles in all possible
conditions.
VARIATION OF THE PRESERVATION CYCLE
You can always select a different preservation
cycle either during the active phase and
during the pause phase of the running cycle.
Repeatedly press button (12) until the LED
that corresponds to the desired cycle is
activated. The LED will flash for 3 seconds
and become steadily lit: The new preservation
cycle is now selected and it will be run for the
set execution times.
Should it become necessary to switch to a
preservation cycle associated to a different
program, you must enable the corresponding
program priorly, by pressing the button (11).
Once you have enabled the program, switch
to the preservation cycle by pressing buttons
(2) and (1) simultaneously for 3 seconds. The
machine will enable the preservation cycles
associated to the preset program.
SWITCHING FROM PRESERVATION PHASE
TO A PRODUCTION PROGRAM
With the preservation active, you can activate
an automatic program simply by selecting it
b y p r e s s i n g b u t t o n ( 1 1 ) . T h e L E D
corresponding to the selected program will
flash for 3 seconds and become steadily lit;
the machine will exit the preservation cycle
and run the selected program.
Subsequently, the preservation cycles
associated to the selected program ill be
enabled.
PADDLE LOCK UPON LID OPENING
The opening of the lid (3) only stops the
10
English
pa ddle (5 ) a nd do es no t a f f ec t the
preservation cycle.
The closure of the lid (3) enables the paddle
operation (5) (on the condition that it is
provided by the selected preservation cycle in
that moment). If the mixture proves
excessively hard and prevents the movement
of the paddle, the machine will automatically
re-activate the preservation cycle from the
start.
TURNING OFF THE MACHINE DURING
PRESERVATION
To turn off the machine, hold down button (11)
for 3 seconds and then act on the main switch
(10). Do not act directly on the main switch
(10)!
IMPORTANT
•Each preservation cycle continues until the
user decides to stop it.
•The machine is not designed for use either
for storage or as a refrigerator! Store the
preparation in the pot for no longer than 12
hours.
•The cooling fan of the cooling system will
always remain in operation for the entire
duration of the preservation period.
•After use, ALWAYS turn the machine off
using the main switch (10).
TIPS
• U s i n g i n g r e d i e n t s a t r e f r i g e r a t o r
temperature will reduce the processing
time. Furthermore, it is possible to reduce
the temperature of the ingredients if hot with
the appropriate fast cooling program.
•Be careful not to insert ingredients that are
too cold or nearly froze, as whipping may
have a poor quality.
•For a correct volume increase during mixing,
use maximum
preparation of ice cream and sorbet.
•For the preparation of Granita, the maximum
amount of ingredients is 2Kg with the paddle
supplied with the machine.
It can process up to 2.7kg of Granita using
the special Granita paddle that can be
purchased separately.
CLEANING THE POT
GELATO 15K CREA is designed to facilitate
2.2
kg of ingredients
for the
Publicidad
