Dreame M12 Manual Del Usuario página 10

Care and Maintenance
EN
Cleaning the Tube and the Dirt Sensor
Remove the Used Water Tank, wipe the tube and the dirt
sensor with a wet cloth before use.
Cleaning the Dust Cup Assembly
* Cleaning the dust cup after each use or after the amount of dust in the cup reaches the MAX line is
recommended.
* Replacing the filter every 3 to 6 months is recommended.
1. Press the dust cup release button and
remove the cup.
3. Tap the filter gently or clean it with the
cleaning brush. Rinse the filter and the
dust cup with water.
15 15
2. Take out the filter and the cyclone
assembly from the dust cup, then empty
the cup.
Note: To reduce the risk
of electric shock or injury,
do not rinse the cyclone
assembly with water.
4. Dry the filter and the dust cup
completely before use.
Care and Maintenance
Cleaning the Brush Assembly
* Clean as needed. Alternating use of the two provided brush rollers is recommended.
* Replacing the brush roller every 3 to 6 months is recommended.
1. First, press the brush roller cover
release buttons inwards on both sides
to remove the brush roller cover. Next,
press the brush roller release
button and the handle of the brush
roller will pop out. Pull the handle to
take out the brush roller.
1
2
3. Wipe the suction inlet with a dry cloth
or wet tissue. Do not rinse the brush
assembly with water.
2. Clean out any hair and debris tangled
on the brush roller with the provided
cleaning brush. Rinse the brush roller
with clean water and dry it completely.
4. After cleaning the brush roller, re-install
the brush roller and the brush roller cover.
You will hear a click to indicate that they
are installed in place.
1
2
EN
16 16