Publicidad
Idiomas disponibles
Idiomas disponibles
FINISH PREPARATION
landing
back side of rail
NO gap
SRE-3000 INSTALLATION 02-08-2019
NOTE: Additional rail brackets may
1. Determine rail bracket placement.
landing
2. Locate and open plastic bag marked
3. Pre-assemble hardware by inserting
4. Determine rail bracket-to-rail orientation,
F
or
front side
of rail
11
PRE-INSTALLATION
be required on upper or lower
landing if rider makes a "hard
transfer" [dropping into seat
by more than 4" (10 cm) from
a standing position or while
transferring from a mobility
device] . These additional rail
brackets prevent movement in
rail during a "hard transfer".*
See Rail Support (Rail Bracket)
Requirements on page 7 for guidelines.
*Additional rail brackets may be
required for longer installations.
Rail brackets may be purchased
from Bruno.
"Stand feet hardware". These components
are used to attach rail brackets
to rail.
bolts into safety washers first and
flat washers second.
which MUST match the figures at left.
Always install rail brackets with long
nose facing the center of staircase.
NOTE: Failure to install rail brackets
in correct orientation may
lead to serious personal injury
and/or property damage!
1-
piece rail installations
s
10
skip to
tep
on next page
©Bruno Independent Living Aids, Inc.
,
.
®
Publicidad
