Publicidad
Idiomas disponibles
Idiomas disponibles
PRE-INSTALLATION
SITE REVIEW AND PREPARATION
RAIL MEASUREMENTS
NOTE: Chair armrest extends
approximately 5 to 8" (127 to 203 mm)
beyond rail at
upper landing,
depending on arm
width setting .
NOTE: Seat height
is adjustable in 1"
increments up to
3" (76 mm).
See page 27
for details .
©Bruno Independent Living Aids, Inc.
1. Visually check out site, making sure all
obstructions (i.e. windows, pipes, bulkheads,
newel posts, etc.) have been taken into
consideration.
2. If stairway is an "open" plan or stairs do not
adjoin a solid wall, access to the stairs must
be paneled off before installation may occur.
3. Determine if stairlift will be installed on the
right or left side of stairs, as viewed from
bottom of the stairs .
1. Determine exact rail length.
NOTE: The rail length will determine the
Measure length of stairway by placing a tape
measure in a straight line on the stairs from
the top step nose to the floor.
STAIR LENGTH = A
(A) Length of Stairway:
(B) Add 12" (305mm) for a
20" (508 mm) seat height:
[Add 1.5" (38 mm) for each 1"
(25 mm) seat height is increased.]
For obstacles at top of stairs:
See Bruno's Brainshark "Ramping the
Rail",
and remember:
Nose-to-floor + nose-to-door + 3" (76mm)
= Overall Rail Length Required
Add Stair Length (A) to
Measurement (C) (i.e., door)
plus 3" (76mm):
Overall Rail Length Required
C
2. Mark Overall Rail Length Required on rail,
measuring from top of rail downwards.
6
®
seat height at the top of the stairs.
SRE-3000 INSTALLATION 02-08-2019
+
+
=
Publicidad
