Bruno SRE-3000 ELAN Manual De Instalación página 36

ELECTRICAL
REPROGRAMMING REMOTE TRANSMITTERS
dip switch
LEARN/ERASE button
©Bruno Independent Living Aids, Inc.
NOTE: Operating channel of the two (2)
Reasons for reprogramming transmitters:
• multiple units in same location;
Reset operating channel of remotes:
1. Remove remote(s) battery access panel.
Fig. 1
2. Locate dip switch labeled 'SW3' (Fig. 1).
3. C hange BOTH dip switch configurations
To reprogram a transmitter:
1. Turn circuit breaker OFF.
2. Remove top mid panel of control enclosure
Fig. 2
3. Locate LEARN/ERASE button on circuit
4. Turn circuit breaker ON, and wait for
5. Clear the memory:
6. Press and hold LEARN/ERASE button
Fig. 3
36
®
remote transmitters included with the
SRE-3000 is pre-set at the Bruno factory .
• remotes need to be replaced.
to one (1) of four (4) possible options:
• 1 up, 2 down (default factory setting)
• 1 up, 2 up
• 1 down, 2 up
• 1 down, 2 down
to expose circuit board (Fig. 2).
board (Fig. 3).
"power-up" beep.
• Hold down LEARN/ERASE button until
LED on circuit board goes out (approx.
12 seconds).
(LED on circuit board is on).
As you continue to press LEARN/ERASE,
press either call/send button on remote
until LEARN/ERASE LED goes out
(approx. 2-5 sec.).
SRE-3000 INSTALLATION 02-08-2019