Seek Thermal AttackPRO Manual Del Usuario página 21

Quick start guide
Quick Start Guide
Please refer to the following to start using the product right away:
1. Charge the AttackPRO battery, either individually or inserted into
the AttackPRO camera (if using the Truck Charger), using the separate
charging dock. Charge for 4 hours before using the camera for the first
time, or until the green LED is indicated on the charging dock.
2. Press and release the green power (left) button to turn the camera
on. The camera should start imaging withing 5 seconds.
3. Quickly press and release the green power (left) button while the
camera is turned on at any time to revert the camera mode back to TI
BASIC.
4. Press and hold the green power (left) button for 3 seconds while
the camera is turned on to power off the camera.
5. Aim the front lens of the camera toward the scene of interest.
6. Quickly press and release the flashlight (right) button to enable the
flashlight; quickly press and release again to disable the flashlight.
7. Press and hold the flashlight (right) button for 3 seconds to toggle
the center reticle and temperature indicator, TI BASIC +. A "+" icon will
appear in the lower left corner of the display.