Seek Thermal AttackPRO Manual Del Usuario página 25

Quick start guide
3. Make sure the Seek Thermal truck charger is properly connected
to a power source as described in the truck charger operating
instructions. A blue light should be displayed on the front of the truck
charger.
4. Pivot the top of AttackPRO camera into the appropriate docking
well on the Seek Thermal truck charger so it engages under the top
mating edge of the truck charger.
5. Allow the handle of the AttackPRO to sit in the mating handle well
of the truck charger and secure product with the retention strap.
6. The charge pins as indicated below should make contact and begin
charging the AttackPRO with battery inserted.
7. A separate battery may also be installed and charged with the Seek
Thermal truck charger by aligning and inserting the top of the battery in the
appropriate well first, then securing with the retention strap.
8. The right LED light on the front of the charger should indicate
RED = charging, GREEN = fully charged, RED FLASHING = error (try
reseating the battery, there may be a battery or charger issue if the
light still flashes).
(+) V (-) GROUND