Publicidad
Idiomas disponibles
Idiomas disponibles
• Verify that it is locked by pulling the tool. Removal of the SDS-plus tool
• Pull back the clamping sleeve (A}, hold and remove the tool.
Accessories may be hot after use. Do not touch the tip of the accessory with your
hand.
Always wear protective gloves to remove the accessory
7.2 Assembly / Disassembly of the auxiliary chuck for drilling in steel, wood and plastic 13 mm (Fig. 2)
Mounting:
• Pull back and hold the SDS chuck locking sleeve A.
• Clean the adapter pin and apply a grease tip to it.
• Push the auxiliary chuck into the SDS chuck.
• Turn slowly to the right.
• Release the locking sleeve A.
Disassembly
• Pull back the clamping sleeve (A), hold and remove the tool.
7.3 Depth guide (Fig. 3)
You can pre-adjust the drilling depth and / or repeat this adjustment using the depth stop. Insert the neces-
sary piercing tip. install the depth stop in the hole of the auxiliary handle and adjust the necessary depth.
7.4 Dust protection cover (Fig. 4)
Slide the device of the dust cover over the drill before performing a vertical drilling with the hammer, above
its head.
7.5 Installation of the auxiliary handle (Fig. 5)
The auxiliary handle can be installed for left or right handed users.
Always use the tool with the correct auxiliary grip assembly.
Built to Exceed
3 YEARS
L I M I T E D WA R R A N T Y
8
Publicidad
