Sharp SJ-F2560EVA-EU Manual De Uso página 11

CHAPTER -3: USING YOUR FRIDGE FREEZER
Alarm
If an alarm light illuminates, contact an authorised service centre.
Press the 's.saver' button to switch the alarm sound off when there is an alarm and an exclamation mark on the display.
The exclamation mark will continue to show on the electronic display panel until the error is fixed.
Compartment On-Off Mode
To turn off Zone1, Zone2 and the cooler at the same time;
Press and hold the [mode] and [cooler] buttons simultaneously for 3 seconds. All figures indicating the part turned
off will disappear on the digital indicator panel.
or
Press and hold the [mode] and [zone 2] buttons simultaneously for 3 seconds. All figures indicating the part turned
off will disappear on the digital indicator panel.
To turn off the Zone1 compartment;
Press and hold the [mode] and [zone 1] buttons simultaneously for 3 seconds. All figures indicating the part turned off
will disappear on the digital indicator panel.
To reactivate the turned-off compartment, use the same combination of buttons.
Using a Freezer Compartment as a Cooler Compartment
The bottom left compartment on the appliance can be used either as freezer or as a cooler.
Press and hold the [zone 1] button for 3 seconds to change the bottom-left compartment from a freezer to a cooler.
IMPORTANT: If the Zone1 compartment is going to be converted from a freezer to a cooler:
• Empty the food from the Zone1 compartment and leave the door closed for four hours. Then food can be placed
in the compartment.
• Baskets and/or shelves removed from the compartment should be re-fitted.
Similarly, in order to utilize any of bottom compartments used as a cooler, as freezers again, press and hold the related
compartment button for 3 seconds.
IMPORTANT: If the Zone1 compartment is going to be converted from cooler to freezer:
• Empty the food from the Zone1 compartment and leave the door closed for two hours. Then food can be placed
in the compartment.
• When the zone 1 compartment is used as a cooler and the appliance is switched to Holiday or Economic
setting, the zone 1 compartment will keep on running as cooler.
Temperature Adjustment Warnings
• The ambient temperature, temperature of the freshly stored food and how often the door is opened affects the
temperature in the refrigerator compartment. If required, change the temperature setting.
• It is not recommended that you operate your fridge in environments colder than 10°C in terms of its efficiency.
• Do not start another adjustment while you are already making an adjustment.
• Temperature adjustments should be made according to the frequency of door openings, the quantity of food
kept inside the fridge and the ambient temperature in the location of your fridge.
• In order to allow your fridge to reach the operating temperature after being connected to mains, do not open
the doors frequently or place large quantities of food in the fridge. Please note that, depending on the ambient
temperature, it may take 24 hours for your fridge to reach the operating temperature.
• A 5 minute delay function is applied to prevent damage to the compressor of your fridge when connecting or
disconnecting to mains, or when a power cut. Your fridge will begin to operate normally after 5 minutes.
• Your appliance is designed to operate in the ambient
temperature (T/N = 16°C - 43°C) intervals stated in the
standards, according to the climate class displayed on the
information label. We do not recommend operating your
appliance out of the stated temperature limits in terms of
cooling effectiveness.
NOTE: If the ambient temperature is higher than 42 °C, the
compartment temperature cannot be set to -23 °C or -24 °C. It
can only be set to -16°C, -17°C, -18 °C, -19 °C, -20 °C, -21 °C
or -22 °C.
Temperature indicator
In order to help you better set your refrigerator, we have equipped it with a temperature indicator located in
the coldest area.
To better store the food in your refrigerator, especially in the coldest area, make sure the message "OK"
appears on the temperature indicator. If « OK » does not appear, this means temperature has not been set
properly
It may be difficult to see the indicator, make sure it is properly lit.Each time the temperature setting device is
changed, wait for the stabilisation of the temperature inside the appliance before proceeding, if necessary,
with a new temperature setting. Please change the position of the temperature setting device progressively
and wait at least 12 hours before starting a new check and potential change.
Climate Class
T
ST
N
SN
EN -9-
Ambient Temperature
o
Between 16 and 43 (°C)
Between 16 and 38 (°C)
Between 16 and 32 (°C)
Between 10 and 32 (°C)
OK
C