Donner B1 Manual Del Usuario página 11

- Press and hold any step button (1-16) for about 2 seconds to flip the REST
REST Flip
setting for that step during sequencer playback, .
(Toggle rest)
- The step light goes out when REST ON, and lights up when REST OFF.
STEP EDIT MODE
Whether the sequencer is playing or not, you can enter the step edit mode and edit the parameters of
the specified step.
Press and hold the REC/EDIT button, then press any step button (1-16), the corresponding step LED
will flash slowly to indicate the step editing mode is on. Then release the REC/EDIT button.
At this point, you can refer to the "Creating Pattern" section and edit parameters like note, gate
length and accent, slide on/off, ratchet, etc.
Press the REC/EDIT button to exit step editing mode. You can also continue to edit other steps by
following steps 1 and 2.
ARPEGGIATOR
- Press the ARP button and the ARP button indicator will light up to indicate arpeggiator mode.
- Refer to the "Setting TEMPO" section to set the tempo value.
- Refer to the "Setting OCTAVE" section to set the octave value.
Note: Press one or more buttons on the keyboard, the arpeggiator will repeat the pressed notes in the
set order. If hold mode is not enabled, the arpeggiator stops playing when the button is released.
- When you enter the arpeggiator, the display will show the current arpeggio options
by default, and you can press ▲ or ▼ to switch from the 8 arpeggio options:
1. UP 1
2. DOWN 1
3. DOWN and UP
Arpeggiator
4. RANDOM
Options
5. UP 2 (+ 1 Oct)
6. DOWN 2 (+ 1 Oct)
7. UP 3 (- 1 Oct)
8. DOWN 3 (- 1 Oct)
- Press HOLD and the HOLD button indicator will flash, at which point the
arpeggiator will remain playing after the keyboard buttons are released.
Hold
- Press the HOLD button again to turn off the hold function.
- Press the GATE LENGTH button, the GATE LENGTH button indicator flashes
and the display shows the current gate length value.
- Press ▲ or ▼ to adjust the gate length value, which can be selected from 1 to 8
Gate Length
(1/8 to 8/8). If you press and hold ▲ or ▼, the gate length value will change rapidly
in succession.
- Press the GATE LENGTH button to exit the gate length setting mode.
- Press the ACCENT button and the ACCENT button indicator will flash, at which
Accent
point an accent effect will be added to each step when the arpeggiator is playing.
- Press ACCENT again to turn off the accent effect.
Press the ARP button again, the ARP button indicator goes out, indicating that arpeggiator mode is
exited.
09