Donner B1 Manual Del Usuario página 8

15. Step 7 slide to step 8
- Press the SLIDE button, the SLIDE button indicator is on to indicate that the Slide of step 7 was turned
on. Step 8 is the target value of the slide in this case.
16. Enter a note to step 8
- Refer to the "Setting OCTAVE" section to set a different keyboard octave range. Then press the button
on the keyboard and enter note. Step LED 8 is blinking and the previous Step LEDs are stop flashing.
17. Exit the record function
- When you have completed your pattern, press REC/EDIT again to exit the Record function.
18. Run the pattern
- Refer to the " SETTING TEMPO " section to set the speed you want, and press PLAY/STOP.
Please see the following table for setting the params during the record function.
1. Press the GATE LENGTH button, the GATE LENGTH button indicator flashes
and the display shows the current gate length value.
2.
Press ▲ or ▼ to adjust the gate length value, the gate length value can be
selected from 0 to 8 (i.e. 0/8 to 8/8). If pressing and holding ▲ or ▼, the gate
length value will be adjusted rapidly in succession.
Set Gate length
Press the GATE LENGTH button to exit the gate length setting mode.
3.
(note duration)
Note:
Gate length is individually adjustable for each step
A gate length of 0 is equivalent to "REST"
A gate length of 8 is equivalent to "TIE"
1.
Press ACCEENT button once, the ACCEENT button indicator is on to indicate
that the current step accent effect is on.
Set accent
Conversely, if the current step accent is on, press ACCEENT once and the
2.
ACCEENT button indicator goes off and the current step accent effect is turned off.
1. Press the SLIDE button once, the SLIDE button indicator turns on and the current
step slide enable is turned on.
Set slide
Conversely, if the current step slide enable is on, press the SLIDE button once,
2.
the SLIDE button indicator goes off and the current step slide enable turns off.
06