Donner B1 Manual Del Usuario página 7

7. TIE step 2 to step 3
- Press the GATE LENGTH button to activate gate length setting mode.
- Press ▲ or ▼ to adjust the gate length value to 8 (equivalent to "TIE").
- Press the GATE LENGTH button to exit gate length setting mode.
(a. If the note value of Step 3 is the same as Step 2, then the note is held through the step transition.
(b. If the note value of Step 3 is different from Step 2, the note is still held through the transition, but
the effect is a legato phrase.
8. Enter a note to step 3
- Enter a new note that is different from Step 2. Step LED 3 is blinking, and the previous Step LEDs
are stop flashing.
9. Set the gate length
- Press the GATE LENGTH button to activate gate length setting mode.
- Press ▲ or ▼ to adjust the gate length value to 1.
- Press the GATE LENGTH button to exit gate length setting mode.
10. Enter a note to step 4
- Enter a new note that is different from Step 3. Step LED 4 is blinking, and the previous Step LEDs
are stop flashing.
- NOTE: When you enter a note, the Gate Length is updated from the previous step. This is useful if
you are entering a pattern with steps that all have the same Gate Length. In that case you would
only need to set the Gate Length when first entering a pattern.
11. Enter a rest for step 5
- Press CLEAR/REST. Step LED 5 is blinking, and the previous Step LEDs are stop flashing.
12. Enter a note to step 6
- Refer to the "Setting OCTAVE" section to set a different keyboard octave range. Then press the
button on the keyboard and enter note. Step LED 6 is blinking and the previous Step LEDs are stop
flashing.
13. Add a ratchet to step 6
- Press the RATCHET button to activate ratchet setting mode.
- Press ▲ or ▼ to select a ratchet value of 2, which will produce 2 notes during the step (up to 4 can
be
selected)
- Press the RATCHET button to exit ratchet setting mode.
14. Enter a note to step 7
- Then press the button on the keyboard and enter note. Step LED 7 is blinking and the previous Step
LEDs are stop flashing.
05