Cameo S2 IP Manual De Usuario página 13

3 DMX IN
Male IP65 5-pin XLR socket for connecting a DMX control device (e.g. DMX console; when not in
use, always close with the rubber sealing cap).
4 DMX OUT
Female IP65 5-pin XLR socket for sending DMX control signal (when not in use, always close with
the rubber sealing cap).
5 NET IN
RJ45 network connector with IP65 protection for connecting to an ArtNet or sACN network. Use
IP65 category CAT-5e or better cable to set up the network (always close with the rubber sealing
cap when not in use).
6 NET OUT
RJ45 network connection with IP65 protection for forwarding the control signal. Use IP65 category CAT-
5e or better cable to set up the network (always close with the rubber sealing cap when not in use).
7 BATTERY IN
Male 4-pin XLR socket with IP65 protection for connecting external batteries (always close with
the rubber sealing cap when not in use; batteries not included). A double V-mount adapter with
connection cable is optionally available (item number CLSVMOUNTAP).
8 LC DISPLAY
The LC display shows the currently activated operating mode (main display), the menu items in
the menu and the numerical value or operating status in certain menu items. If no entry is made
within approximately one minute, the display automatically changes to the main display. Note on
the main display in the operating modes with external control: As soon as the control signal is
interrupted, the characters in the display start flashing; if the control signal is present again, the
flashing stops.
9 DIM / SELECT / ENTER
Rotary-push encoder for the adjustment and control of the spotlight.
DIM - In the stand-alone modes CCT, HSI, Direct LED, Colour Coordinates, Gel, User Colour, Play
Loop and Light Simulation, the encoder has the function of the master dimmer (turn encoder).
SELECT - Turn the encoder to select the menu items on the menu level and change a value in a
menu item (e.g. DMX start address).
ENTER - 1. Pressing ENTER takes you to the menu level for selecting the operating mode. 2. You
move down one level in the menu structure. 3. Press ENTER to confirm a value or status change,
such as changing the DMX start address.
13