Cameo S2 IP Manual De Usuario página 23

EZ REMOTE CONTROL VIA CAMEO UNICON (optionally available)
Starting from the main display, press the left-hand rotary-push encoder to access the menu
for selecting the operating mode. Turn the left encoder (SELECT) to select EZ Remote (note the
selection arrow on the left) and confirm by pressing the left encoder (ENTER). Now set the desired
fixture ID (Fixture ID 1 - 8) by turning the left encoder (SELECT) and confirm by pressing the left
encoder (ENTER).
Connect the spotlight and UNICON using a DMX cable, select DMX Control in the UNICON menu,
then EZ Remote, and enter the same unit ID. Now control the spotlight using RGB, GEL, CCT or
HSI. By assigning different unit IDs, up to eight spotlights (or spotlight groups) can be controlled
separately via UNICON.
SLAVE MODE
Starting from the main display, press the left-hand rotary-push encoder to access the menu for
selecting the operating mode. Turn the left encoder (SELECT) to select the slave (note the selec-
tion arrow on the left) and confirm by pressing the left encoder (ENTER). Connect the slave and
the master units (same model, same software version) with a DMX cable and enable a standa-
lone mode on the master unit. The slave unit will now follow the master unit. The control signal
can alternatively be transmitted via W-DMX. Enable W-DMX in both the master and slave units.
Configure the master unit as transmitter, the slave unit as receiver and pair the units (Settings ->
Wireless Settings).
SYSTEM SETTINGS (Settings)
Starting from the main display, press the right-hand rotary-push encoder to access the menu for
selecting the operating mode (Menu). Turn the left encoder (SELECT) to select Settings (note the
selection arrow on the left) and confirm by pressing the left encoder (ENTER).
This takes you to the submenu for setting the submenu items (see table, select by turning the left
encoder , confirm with ENTER, change value or status by turning the left encoder, confirm with
ENTER).
23