Cameo S2 IP Manual De Usuario página 16

W-DMX STATUS
™
W-DMX W-DMX
as receiver
deactivated
activated,
not paired
SETTING DMX START ADDRESS (DMX address)
Starting from the main display, press the rotary-push encoder to enter the main menu. Turn the
left encoder (SELECT) to select the menu item DMX Address (note the selection arrow on the left)
and confirm by pressing the encoder (ENTER). You can now configure the DMX start address as
required by rotating the encoder (the highest value depends on the selected DMX mode). Confirm
the entry by pressing the left encoder (ENTER), this also automatically takes you back to the main
display and the DMX operating mode is activated. At the same time, the DMX start address follo-
wing the selected start address plus the channel number of the selected DMX mode is displayed
(Next Free Address). The menu item for selecting the desired DMX mode can be reached directly
from the menu item DMX Address by pressing the middle rotary-push encoder (DMX mode); the
previously set DMX start address is automatically saved.
CONFIGURING DMX MODE (DMX Mode)
Starting from the main display, press the rotary-push encoder to enter the main menu (MENU).
Turn the left encoder (SELECT) to select the menu item DMX Mode (note the selection arrow on
the left) and confirm by pressing the left encoder (ENTER). Now you can select the desired DMX
mode by turning the left encoder. Confirm the selection by pressing the left encoder (ENTER), this
also automatically takes you back to the main display and the DMX operating mode is activated.
The menu item for setting the desired DMX start address can be reached directly from the menu
item DMX Mode by pressing the middle rotary-push encoder (DMX Address); the previously
selected DMX mode is automatically saved. Tables with the channel assignment of the different
DMX modes can be found in these instructions under DMX CONTROL.
ENABLE EXTERNAL CONTROL VIA DMX, ARTNET AND SACN
Starting from the main display, press the left-hand rotary-push encoder to access the menu for
selecting the operating mode. Turn the left encoder (SELECT) to select DMX (note the selection arrow
on the left) and confirm by pressing the left encoder (ENTER). Now the control protocol that was
preselected in the menu item Protocol in the main menu is activated (DMX512 / Artnet / sACN).
To configure the two control protocols Artnet and sACN as desired, press the right encoder (Menu),
then select Protocol and confirm (Enter). Select the desired protocol, confirm, now select the
submenu items for setting and confirm again (see table).
16
W-DMX W-DMX
as receiver as receiver as receiver
activated activated
and and
paired, paired,
Transmitter no DMX signal
switched off DMX signal is present
or out of
range
W-DMX W-DMX W-DMX
as trans- as trans-
activated mitter
and with G3
with G4s
paired, standard standard
activated, activated,
DMX signal DMX signal
is present is present
W-DMX W-DMX
as trans- as trans-
mitter mitter
with G3 with G4s
standard standard
activated, activated,
no
DMX signal DMX signal
mitter
no