Stiga RC 585 Manual De Instrucciones página 135

3. Adjustment and use of clutch:
Note: Before using the clutch, lower the engine speed.
• By "engage " and "disengage "of the clutch, the user can control output of engine's power.
• When the user holds tight the clutch lever, the clutch is engaged and transmits engine power to the
tiller and tilling blades begin to rotate (See Fig. 7).
Figure 7
• When the user releases clutch lever, clutch will be disengaged, and the engine power can't be
transmitted to the tiller, and tilling blades stop rotating (See Fig. 8).
Note: Before adjusting height of handle frame, please put the machine on a flat horizontal
ground to prevent it from accidental falling.
• First confirm tension of clutch cable. Normally the cable shall have a 4~8mm degree of freedom, if
not, please loosen the locking nut and adjust the cable, and tighten the locking nut after finishing
adjustment (See Fig. 9).
• If necessary, the user may start the engine to check whether the clutch can engage and disengage
properly.
Figure 9
EN
Figure 8
7