Hoshizaki DBF-AS65WE-EU-HC Manual De Instrucciones página 22

The CO2 gas pressure on the beer keg must not exceed 0.37 MPa. Otherwise, the beer keg or hose can explode resulting in
injury.
The CO2 gas pressure on the beer keg prevents separation of CO2 gas from beer. The higher the beer keg temperature is, the
easier the CO2 gas separates and a higher gas pressure is required.
Beer Keg Temperature
10°C
20°C
30°C
[c] CHECKING BEER KEG
If the sold out lamp comes on and no more beer is dispensed, replace the beer keg.
Do not store an open beer keg in a refrigerator. But keep it under 30°C.
[d] REPLACING BEER KEG
Do not loosen the ferrule on the beer keg, or inside pressure may blow off the ferrule resulting in injury.
Handle the beer keg with care to avoid vibration. Rolling or shaking the beer keg can cause excessive foaming.
Keg Coupler Handle
1) Close the beer circuit.
Rotary type: Turn the keg coupler handle counterclockwise until it stops.
Vertical type: Unlock and lift the keg coupler handle all the way up.
2) Turn the regulator adjust dial to set the pressure to "0" (MPa).
3) Turn the keg coupler counterclockwise to
remove it from the beer keg.
4) Turn the keg coupler clockwise to attach it to the new beer keg.
Note: Wash the joint between the keg coupler and beer keg if it is not clean.
5) Turn the regulator adjust dial to set to an appropriate pressure according to the beer
keg temperature. See "[b] REPLACING CO2 GAS CYLINDER".
Gas Pressure
0.20 MPa (Scale 2)
0.22 MPa (Scale 2.2)
0.32 MPa (Scale 3.2)
Keg Coupler
Beer Keg
Rotary Type
Rotary Type
WARNING
Note: The values are for reference only. Set to the appropriate
pressure specified by the beer company.
WARNING
Vertical Type
Vertical Type
15
ENGLISH
Keg Coupler Handle
Keg Coupler
Beer Keg
Keg Coupler Handle
Rotary Type Vertical Type
Rotary Type Vertical Type