MBM BRG98A/912T Manual De Instalación página 47

When filling the cooking com-
partment, respect the maximum
level indicated by the notch on
the inside (Fig. 4 A).
Water may be introduced into
the cooking compartment by
acting on the water filling gate
valve: open, adjust the amount of wa-
ter you wish and close again.
In order to fill the cooking com-
partment with water, you must:
- lift the lid of the cooking com-
partment if necessary,
- turn the water outlet pipe towards the
cooking compartment,
- open the water inlet gate valve (e.g. 900
Mod. Fig. 5),
- fill the bowl as required and then close
the gate valve (e.g. 900 Mod. Fig. 6)
- position the water outlet pipe so it
does not get in the way of the lid when
it closes. Lower the lid of the cooking
compartment if necessary.
Do not use large pieces of ki-
tchen salt as it deposits at the
bottom and does not comple-
tely dissolve. Do not introduce salt in
cold water.
Load the product to be cooked inside
the cooking compartment.
When it has been loaded, lower the lid
(Fig. 3) and switch the appliance on, if
necessary.
SWITCHING ON / OFF
When lighting for the first time,
wait for the possible formation of
air inside the gas circuit to fully
escape from the duct.
Repeat the operation if after 20"
the pilot light is not yet lit. If the
pilot light does not ignite, con-
tact the authorized technical assistan-
ce Centre.
700 MODEL / see SECT. IMAGES
- REF. o).
•
Press the button (Fig. 7A) for about 20"
and simultaneously press the piezoe-
THE PRESENT MANUAL IS PROPERTY OF THE MANUFACTURER. ANY REPRODUCTION, EVEN PARTIAL, IS PROHIBITED.
INSTRUCTIONS FOR USE
lectric button several times (Fig. 8) until
the pilot light is lit.
•
After approximately 20" look to see
if the pilot light remains lit (Fig. 9). If
so, release the button.
•
The pilot light can be seen through
the hole on the panel.
•
When the pilot light has been lit, turn
the thermostat knob to the switch-on
position (Fig. 7B) and adjust the tem-
perature (Fig. 7C) using the 8 thermo-
stat positions. See layout below.
POS.
1
2
3
4
5
6
7
8
•
Turn the thermostat knob to "Zero"
(Fig. 7D) to switch the burner off.
When the work cycle is over, in or-
der to speed up a new production
cycle, you may turn the burner off
while leaving the pilot light on.
•
Press the "0" button (Fig. 7E) to block
the gas supply to the pilot light and
stop the appliance completely.
900 MODEL / see ILL sect. - REF o)
- Turn the knob (Fig. 10A). Lighting of
the green indicator (Fig. 10B) confirms
the electrical operation phase.
- Turn the knob while holding it in the
piezoelectric position (Fig. 10D) until the
pilot light ignites.
- After about 20 seconds, check to make
sure the pilot light remains lit (Fig.11)
and then release the button.
- 19 -
8.
EN
TEMP.
90°C
130°C
180°C
210°C
240°C
260°C
290°C
300°C