Cramer 82LT107 Manual Del Usuario página 13

Error Code Description
V18 Battery compartment (PMU) failure
V22 blade signal abnormal
V21 PMU CAN communication error
V23 Operator presence switch abnormal Check that the connector under the seat is connected prop-
ML3 Left blade software overcurrent
ML4 Left blade stalled
ML6 Left blade MOS error
ML7 Left blade motor phase loss
ML9 Left blade controller temperature
abnormal
ML14 Left blade hardware overcurrent
ML15 Left blade failed to start
MR3 Motor lowspeed protection
MR4 Motor overspeed protection
MR6 Motor Hall-sensor error
MR7 Controller phase loss
MR9 MOSFET open circuit error
MR14 Controller undervoltage
MR15 Controller overvoltage
PMU10 Battery pack open circuit error
PMU11 PMU major error
PMU12 PMU secondary error
PMU13 No battery pack available
PMU Insufficient battery packs available,
functionality may be limited.
English
Solution
Check that the accelerator cables are connected properly
and restart the power supply.
Check that the blade start switch is connected properly, and
then return the switch to its initial position.
Communication with the battery compartment timed out. Re-
start the power supply.
erly, and then restart the power supply.
Check the mowing load and restart the power supply.
Check the mowing load and return the blade start switch to
its initial position.
If you encounter this issue, contact your distributor for a
solution.
Check that the blade controller and motor cables are con-
nected properly, and then restart the power supply.
The controller temperature is too high. Wait for the controller
to cool down, and then restart the power supply
Check the mowing load and restart the power supply.
Check the mowing load and return the blade start switch to
its initial position.
Check the mowing load and restart the power supply.
Check the mowing load and return the blade start switch to
its initial position.
If you encounter this issue, contact your distributor for a
solution.
Check that the blade controller and motor cables are con-
nected properly, and then restart the power supply.
The controller temperature is too high. Wait for the controller
to cool down, and then restart the power supply.
Check the mowing load and restart the power supply.
Check the mowing load and return the blade start switch to
its initial position.
The temperature of the battery compartment and battery is
too low. Use the machine at a suitable temperature and
restart the power supply.
The temperature of the battery compartment and battery is
too high. Wait for the battery to cool down, and then restart
the power supply.
A major error in the battery compartment prevented the
drive and blade systems from starting. Restart the power
supply and try again.
Check that you are using the correct battery pack, and then
restart the power supply.
Please insert more battery packs.
13
EN