Cramer 82LT107 Manual Del Usuario página 15

5. Remove the blade nut, spacer, blade insulator, and blade.
6. Thread the blade nut on the shaft and finger tighten.
7. Torque the blade nut down clockwise using a torque wrench (not provided) to ensure the bolt is properly
tightened. The recommended torque for the blade nut is 90 N.m~100N.m (66~74 ft.lbs).
Ensure blade is properly seated and the blade nut is tightened to the torque specifications above. Failure to
properly attach the blade could cause it to come loose and result in possible serious personal injury.
8. Repeat with second blade, if needed.
Make certain all parts are replaced in the exact order in which they were removed.
7.2 REPLACE THE HEADLIGHT
See figure 18
Call customer service or visit our website online to order a new headlight.
1. Park the mower on a level surface and set the parking brake.
2. Stop the motor and remove the start key.
3. Remove and set aside the hex head screw and flat washer holding the mower floor panel in place.
4. Lift floor panel slightly to access the two hex head screws and flat washers securing the headlight in place.
Remove screws and washers and set aside.
5. Unplug the old headlight and discard.
6. Plug in new headlight and reinstall washers and screws. Tighten securely.
7. Lower floor panel and reinstall washer and screw to secure.
7.3 TIRES
It is important for level mowing that all tires have the correct amount of air pressure. The recommended pressure are:
Tire pressure should only be measured or adjusted when tires are cold.
Drive wheels
Front caster wheels
Inspect the tires daily. Replace immediately if damaged.
Check the tire pressure carefully while inflating. Too much air in the tire could cause the tire to burst, causing
serious personal injury.
7.4 LUBRICATION
See figure 19
Please add oil before operation.
Oil type
Oil capacity
Contact your Cramer dealer to replace the lubrication.
English
WARNING
NOTE
NOTE
8 psi
24 psi
NOTE
WARNING
SAE85W-140
180 ml
15
EN