AERMEC VED I Serie Manual De Uso E Instalación página 31

8.7. CONTROL DEVICE (NOT INCLUDED)
CONTROL DEVICE 0V - 10V
Use a control device with thermostat and
speed control of the fan with a 0-10V out-
put and with characteristics compatible
with the fan coil unit.
For the installation consult the unit manual
VMF System CONTROL DEVICE
VMF-E18
VMF-E4
and the accessory manual.
With thermostat VMF-E18 and with con-
trol panel VMF-E4 or VMF-E4D.
• The thermostat kit VMF-E18 includes
the cables for connection to the Inverter
Command Module. The cables are termi-
nated with connectors for a rapid connec-
tion. The installation of the VMF-E18 kit
requires that the standard terminal block
and the connection cables to the Inverter
Command Module are removed from the
fan coil unit (Signal e Supply).
• Mount the thermostat box on the side of
the fan coil unit, on the connections that
were used for the terminal block.
• Remove the cover to the thermostat box.
• Connect the Inverter Command Module
to the VMF-E18 thermostat using the
cables provided with the VMF-E18 kit.
Check the connections with the wiring
diagram.
• Connect with the wired control panel
VMF-E4 or VMF-E4D.
• Complete the connections as shown in
the VMF-E18 thermostat manual.
4880950_03 - 1811
31