1- Warnings; 2- Alarms - BSV BSPOOL BSsalt-10 Manual De Usuario

4.3.1- Warnings

Message:
"LACK OF SALT"
"EXCESS SALT"

4.3.2- Alarms

"NO WATER
FLOW"
"OVERLOAD"
The 4 production
LEDs (%) will
flash.
(Open circuit)
Manual EVO v.4
Causes:
Lack of salt in the water.
Incrustations or objects in
the electrolysis cell causing
lack of current.
The electrolysis cell
worn.
Excess salt in the water.
Incrustations or objects in
the electrolysis cell causing
excess current.
Excess gas in
electrolysis cell. It may be
because the pump
shutdown. The gas
hydrogen gas which
highly flammable.
Sensor cable of the cell is
incorrectly connected
broken.
Cell sensor is dirty.
No water flow
The cell is incorrectly
connected.
Metal body in the cell.
Cell is incorrectly
connected.
Cell is damaged
completely worn down.
Action required:
Add salt to the swimming
pool.
Clean the cell.
is Replace the electrolysis cell
with a new one.
No action required if excess
is not very significant.
Clean the cell.
the The piping
drained to eliminate gas or
has accumulated water. Check
is the pump.
is
Check the sensor cable
or (white cable)
Clean.
See maintenance.
Check the water system
Check wiring.
Turn off the equipment and
remove the metal body
from the sheets
Check the cell connection
and ensure that cables and
connection terminals are in
good condition.
or Check the condition of the
cell electrodes, and replace
it if any
observed.
should be
damage is
102 / 166