Publicidad
Idiomas disponibles
Idiomas disponibles
PUTTING INTO OPERATION
CAUTION:
When working on the brushcutter always be absolutely certain to switch off the engine, pull the
spark plug cap and wear protective gloves!
IMPORTANT: Do not start the brushcutter until fully assembled and inspected!
Mounting the tube handle
The handle tube (A/1) comes fixed parallel to the main tube.
1
2
A
-
Use the universal wrench to loosen the locking screw
(A/2) (counter-clockwise) until it is possible to turn the tube
handle through 90
0
.
Installing the cutter guard
IMPORTANT: Safety regulations and your own safety make it imperative to use the right cutter guard with a
given cutting tool! Use only the combinations shown here, and when switching to a different
cutting tool always change the cutter guard as well!
WARNING:
Use only the cutting tools shown here! It is not permitted to use other cutting tools as this can
increase danger of accidents and cause damage to the equipment!
Tool/guard combinations for the MS-3310, MS-4010 and MS-4510
Cutting tool
Steel bush cutter, part no. 385 224 130
Outside diameter 300 mm (12"), arbour 20 mm
8-tooth eddy blade, part no. 385 224 180
Outside diameter 255 mm (10"), arbour 20 mm
Star blade, part no. 385 224 140
Outside diameter 255 mm (10"), arbour 20 mm
2-line trimmer head, part no. 385 224 501
4-line trimmer head, part no. 385 224 541
Cutting range 400 mm (16"). Use only 2.4 mm (.095") replacement cutting line.
15 m part no. 369 224 070
120 m part no. 369 224 072
Chisel type saw blade, part no. 385 224 160
Outside diameter 225 mm (9"), arbour 20 mm
Chisel type saw blade, part no. 385 224 170
Outside diameter 200 mm (8"), arbour 20 mm
10
STOP
0
90
B
-
After the tube handle has engaged in the 90° position,
tighten the locking screw (B/2) a little, while still leaving it
loose enough to allow further adjustment of the tube handle
according to your size (See "Balancing the brushcutter").
-
Move the handle tube into a position approximately 45°
with respect to the main tube (C).
Cutter guard
Part no. 010 341 612
Part no. 010 341 612
Part no. 010 341 612
part no. 010 341 612
* Install line cutter (knife),
part no. 957 341 010!
part no. 010 341 100 (for 225 mm)
Impressed: 385 341 045
part no. 010 341 030 (for 200 mm)
Impressed: 385 341 030
45
2
C
*
0
Publicidad
