Publicidad
Idiomas disponibles
Idiomas disponibles
Putting into operation
Observe accident-prevention regulations!
Do not start the brushcutter until fully assembled and
inspected!
Starting the engine
-
Move at least 10 feet (3 meters) away from where you filled
the fuel tank.
-
Make sure you have a good footing, and lay the brushcutter
on the ground in such a way that the cutting tool is not
touching the ground or anything else.
Cold start
6
7
G
-
Move the switch (G/6) in the direction of the arrow.
-
To set the half-throttle catch, press the throttle (G/8) with
the throttle trigger lockout (G/7) pressed and then press
the catch (G/10). Release the throttle (G/8) and then the
throttle trigger lockout (G/7).
I
-
Hold the brushcutter frimly down with one hand, as
illustrated above.
-
Pull the starter handle out slowly until resistance is noticed,
then pull the starter handle out fully with a quick and forceful
movement.
-
Do not pull out the whole starter cable to its full extent and
do not let the starter handle jump back, but let it slowly
automatically rewind itself.
-
Repeat starting procedure until ignition is achieved.
-
Turn the choke lever (H/9) back up and pull the starter
cable again until the engine starts.
16
10
8
H
-
Turn the choke lever (H/9) downwards to choke the engine.
6
J
-
After the engine has started, press the throttle (J/8) all the
way in and release immediately. This will disengage the
half-throttle position.
-
Run the engine for approximately 1 minute at a moderate
speed before commencing work.
Warm start
Similar to a cold start but without the choke.
Turning off the engine
Move switch (J/6) to the position
9
8
.
STOP
Publicidad
