dormakaba La Gard 700 Serie Guia De Instalacion página 6

b. For the Deadbolt and Springbolt application, use the retainer type shown above in Blue.
3. Feed the lock cable through the hole in the baseplate so that it emerges from the other side of the safe
door.
4. Line up divot on bottom of keypad body with triangular mark on baseplate (see arrows on diagram
below). Once aligned, install by pressing the keypad up against the baseplate, then rotating clockwise
until the keypad latches in place.
5. If installing a deadbolt or springbolt, do the following:
a. Make sure that the keypad is in its vertical orientation (not rotated to the side).
b. From the inside of the safe door, insert the spindle through the central hole into the square
opening in the baseplate. Orient the spindle so that the groove in the spindle faces upward if you
used the vertical screw holes or faces to the right if you used the horizontal screw hole pattern.
Place the spindle such that the lock cable runs inside of or alongside the groove.
c. Measure .354 inches (9.0mm) past the edge of the safe door and mark the spindle with a pen or
marker.
d. Remove the spindle from the safe door, then cut the spindle to the appropriate length as
determined in step c.
e. Place the newly cut spindle into the keypad, then route the cable the same way as described in
step b.
dormakaba USA Inc. | Keypad Installation Guide 7033.0322 Rev D 07/22
5