dormakaba La Gard 700 Serie Guia De Instalacion página 8

5. Feed the keypad cable through the hole in the baseplate so that it emerges from the other side of the safe
door.
6. Line up divot on bottom of keypad body with triangular mark on baseplate.
7. Once aligned, install by pressing the keypad up against the baseplate, then rotating clockwise until the
keypad latches in place. At this point, it should be vertically aligned.
8. Push retaining latch back into the housing port to hold the keypad in place and prevent it from rotating
and falling off the safe door.
9. If installing a deadbolt or springbolt, do the following:
a. Make sure that the keypad is in its vertical orientation (not rotated to the side).
b. From the inside of the safe door, insert the spindle through the central hole into the square
opening in the baseplate. Orient the spindle so that the groove in the spindle faces upward if you
used the vertical screw holes or faces to the right if you used the horizontal screw hole pattern.
Place the spindle such that the lock cable runs inside of or alongside the groove.
c. Measure .354 inches (9.0mm) past the edge of the safe door and mark the spindle with a pen or
marker.
d. Remove the spindle from the safe door, then cut the spindle to the appropriate length as
determined in step c.
e. Place the newly cut spindle into the keypad, then route the cable the same way as described in
step b.
Connect a Safe Lock to a Keypad
Once the Keypad and safe lock(s) are physically installed onto the safe, they can be connected to form a
System. Follow these steps to connect a safe lock to a Keypad:
1. For single lock Systems, do the following:
a. Connect the cable from the Keypad into the ENT port. With the lock connected, apply power to
the system. If a Battery Box, Alarm Box or AC power adapter is used, plug the cable from any of
those accessories into the safe lock BAT port (as shown in the diagram below)
b. Follow the on-screen prompts for Display Keypads or consult the System User Guide (Document
#7040.1121) for non-Display Keypads to enter the lock settings and initialization
2. For multi-lock Systems, do the following:
dormakaba USA Inc. | Keypad Installation Guide 7033.0322 Rev D 07/22
7