Publicidad
①
4
②
③
④
English
TO OPEN/CLOSE SHIELD
To open, push the shield latch lever up and the shield will open slightly ①. Then pull
the bulge on the shield slightly outward so the shield clears the latch post on the
helmet ②, and raise the shield.
WARNING :
Do not attempt to open the shield without using the latch system, or
push down on the shield latch lever ③, as damage to the latch system may occur.
To close, push the shield down until the latch post fully engages the shield and the
latch lever captures the bottom of the shield ④.
WARNING :
Be sure to latch the shield properly before riding. If not latched
securely, the shield may open unexpectedly from wind pressure, vibration or even
normal head movement.
Silicone lubricant is supplied with your helmet for routine maintenance if the shield
operation becomes stiff, flexing excessively as you raise and lower it. First clean
the shield, eye port trim and pivot mechanism. Apply a drop of the supplied silicone
lubricant to the sliding slots and brass studs. You can also apply one or two drops to
the sealing surface of the eye port trim and spread evenly across the entire surface.
Wipe off excess silicone with a soft tissue paper.
Publicidad
