Publicidad
①
OPEN
OPEN
CLOSE
OPEN
①
④
8
②
CLOSE
CLOSE
CLOSE
CLOSE
OPEN
OPEN
②
⑤
English
TO OPERATE MOUTH VENT
The Mouth Vent is operated by simply pulling the vent control down to open, pushing
up to close.
TO OPERATE TOP VENTS
Simply push the switches/levers on each vent to open/close the vents.
Do not carry the helmet by the rear vent.
NOTE :
Do not use oils or waxes to lubricate vents or other moving parts. If you
must lubricate such components, sparingly use the silicone lubricant supplied
with your helmet for eyeport trim dressing.
TO REMOVE/REPLACE SHIELD
③
To remove, place shield in the fully open position ①. Push the side pod release lever
from the front edge of the side pod backward ② to release the side pod ③.
⑥
Then lower the shield until the brass stud of the shield moves into the red hole of the
base plate ④. Remove the shield from the spring clips ⑤＆⑥, and repeat for the
other side.
Publicidad
