Publicidad
①
6
②
English
WARNING :
If your shield becomes too scratched or uncleanable, replace it with a new one.
Impaired visibility causes accidents.
Use a solution of mild soap or detergent and lukewarm water to clean your shield.
Rinse well with clean water, and wipe off with a soft cloth. Never use petrol,
thinner, benzene or any other solvents. There are many "aggressive" cleaners on
the market, including some supposed to be specifically for use on shields. Arai
strongly recommends that you do not use any such products to clean your shield
as some of their ingredients may have damaging effects on the shield and other
plastic parts installed on your helmet.
Do not apply stickers or adhesive tape to the shield, as this will weaken the hard
coating. Tinted or mirrorized shield is for daylight use or in high visibility conditions
only. Never use tinted or mirrorized shield at night or in poor visibility conditions.
TO OPERATE DEMIST SYSTEM
A demist function is incorporated in the shield latch system to allow more rapid
clearing of any interior mist with the shield remaining partially latched. Push the
shield latch lever up to release shield into the demist position to assist moisture
dispersal ①. To close the shield completely, push the shield down until the latch post
fully engages the shield and latch lever captures the bottom of the shield ②.
TO OPERATE BROW VENTS
The Brow vents are operated from fully closed through intermediate, to fully open
positions by simply pulling the vent control down to open, pushing up to close.
Publicidad
