Publicidad
Idiomas disponibles
Idiomas disponibles
us_main.book.book Page 71 Tuesday, September 6, 2022 9:13 AM
Problem
Oven temperature
Oven sensor needs to be adjusted.
too hot or too cold
• See the "Adjusting the Oven Thermostat" section in the Operation chapter.
Excessive smoking
Excessive soil.
during a Self Clean
• Turn off the Self Clean function. Open the windows to rid the room of smoke. Wait until the
cycle (On some
models)
Burning or oily odor
This is normal in a new oven.
emitting from the
• This will disappear in time. To speed the process, set a Self Clean cycle for a minimum of 3
vent
Moisture collects on
This happens when cooking foods high in moisture.
oven window or
• This is normal.
steam comes from
oven vent
Excessive moisture was used when cleaning the window.
• Do not use excessive moisture when cleaning the window.
Parts & Features
Problem
Range is not level.
Poor installation.
• Place oven rack in center of oven. Place a level on the oven rack. Adjust leveling legs at
• Be sure floor is level and strong and stable enough to adequately support range.
• If floor is sagging or sloping, contact a carpenter to correct the situation.
Kitchen cabinet alignment may make range appear unlevel.
• Be sure cabinets are square and have sufficient room for range clearance.
Cannot move
Cabinets not square or are built in too tightly.
appliance easily.
• Contact builder or installer to make appliance accessible.
Appliance must be
accessible for
Carpet interferes with range.
service.
• Provide sufficient space so range can be lifted over carpet.
Anti-tip device engaged.
• Uninstall the anti-tip device to move the range. Reengage the anti-tip device after pulling
Surface units will not
Improper cookware being used.
maintain a rolling
• Use pans which are flat and match the diameter of the surface unit selected.
boil or cooking is not
fast enough.
In some areas, the power(voltage) may be low.
• Cover pan with a lid until desired heat is obtained.
Surface units do not
A fuse in your home may be blown or the circuit breaker tripped.
work properly.
• Replace the fuse or reset the circuit breaker.
Cooktop controls improperly set.
• Check to see the correct control is set for the surface unit you are using.
Self Clean mode is cancelled. Wipe up the excess soil and reset the clean.
hours. See the Self Clean section. (On some models)
base of range until the oven rack is level.
the range out for cleaning, service, or any other reason.
TROUBLESHOOTING
Possible Cause & Solution
Possible Cause & Solution
71
Publicidad
