Webasto ProCore Edge 30 Manual De Instalación, Funcionamiento Y Mantenimiento página 50

ProCore Edge 30 North America
9.1.4.1. Single-Cable Connection
For a single-cable-connection, start by disconnecting the end of
the cable from the termination block located at the very bottom of
the charger. Then unplug the communications, starting from the
bottom power module, until the module to be replaced has been
disconnected. (Figure 29)
NOTE
The ribbon cable has a red edging to denote Pin 1. While facing the
module, always insert the connectors so the cable red line is on the left.
5912995 A01
Figure 29 Single-Cable Connection
50 of 68
Webasto Charging Systems, Inc.
IOMM