Dreame DreameBot L20 Ultra Manual De Usuario página 13

Routine Maintenance
EN
Filter
1. Remove the filter and tap its basket gently.
Note: Do not attempt to clean the filter with a brush, a finger or sharp
objects to prevent damage.
2. Rinse the dust box and filter with water and dry them completely
before reinstalling.
Note:
·
Rinse the dust box and filter with clean water only. Do not use any
detergent.
·
Use the dust box and filter only when they are completely dry.
22
Robot Sensors and Charging Contacts
Wipe sensors and charging contacts of the robot by using a soft and dry
cloth, as shown in the below figure:
AI Visual Sensor
Line Laser Sensors
LED Fill Lights
Laser Distance Sensor (LDS)
Edge Sensor
Bumper
Charging Contacts
Cliff Sensors
24h
Carpet Sensor
Note: A wet cloth can damage sensitive elements within the robot and
the base station. Please use a dry cloth for cleaning.
Routine Maintenance
Charging Contacts
Clean the charging contacts and the signaling area of the base station with a
soft and dry cloth.
Auto-empty Vents
Clean the auto-empty vents of the robot and the base station with a soft
and dry cloth.
Mop Pad
Remove the mop pad from the mop pad holder to replace it.
Cleaning Solution Adding Inlet
If the cleaning solution adding inlet is dirty, wipe it with a soft and dry cloth.
Battery
The robot contains a high-performance lithium-ion battery pack. Make
sure that the battery remains well-charged for daily use to maintain
optimal battery performance.
EN
23