Toshiba RAV-SM564UT-E Manual De Instalación página 24

+00EH99858901_01EN_4-way_IM_printOnly.book Page 23 Tuesday, December 4, 2007 2:31 PM
4-way Air Discharge Cassette Type
Change of lighting time of
filter sign
According to the installation condition, the lighting
time of the filter sign (Notification of filter cleaning)
can be changed.
Follow to the basic operation procedure
1 2 3
→ →
(
• For the CODE No. in Procedure
• For the [Set data] in Procedure
setup data of filter sign lighting time from the
following table.
Setup data
0000
0001
0002
0003
0004
To secure better effect of
heating
When it is difficult to obtain satisfactory heating
due to installation place of the indoor unit or
structure of the room, the detection temperature of
heating can be raised. Also use a circulator, etc.
to circulate heat air near the ceiling.
Follow to the basic operation procedure
1 2 3
→ →
(
• For the CODE No. in Procedure
• For the set data in Procedure
data of shift value of detection temperature to
be set up from the table below.
Setup data
0000
0001
0002
0003
0004
0005
0006
23-EN
4 5 6
→ → →
).
3
, specify [01].
4
, select the
Filter sign lighting time
None
150H
2500H (At shipment from factory)
5000H
10000H
4 5 6
→ → →
).
3
, specify [06].
4
, select the setup
Detection temp shift value
No shift
+1°C
+2°C (At shipment from factory)
+3°C
+4°C
+5°C
+6°C
To select horizontal wind
direction
1. Push and TEMP.
four seconds when the air conditioner is not
working.
flashes.
Indicates CODE No. "01."
2. Select an indoor unit to be set by pushing
button (left side of the button).
Indoor unit number changes each time you
push the button.
Unit No.
1-1
Not
display
The fan of the selected unit runs and the
louvers start swinging.
3. Change the CODE No. to "45" with
TEMP.
4. Select wind direction setting with TIME
buttons.
Wind
direction
setting code
0000
contamination) [Factory Shipping]
0002
(Air direction to control cold air fall)
5. Push button to check the setting.
The display state changes from flashing to
lighting, and the setting is fixed.
6. Push button to end the setting.
* When the cold draft position is selected, ceiling
contamination is less reduced.
How to set up swing type
1. Push for at least four seconds when the
air conditioner is not working.
flashes.
Indicates CODE No. "F0."
2. Select an indoor unit to be set by pushing
(left side of the button).
Each time you push the button, unit numbers
change as follows:
Unit No.
1-1
Not
display
The fan of the selected unit runs and the
louvers start swinging.
– 23 –
Installation Manual
buttons for at least
Unit No. Unit No.
1-2 1-3
Unit No.
1-4
buttons.
Wind direction setting
Smudge reducing position
(Air direction to reduce ceiling
Cold draft position
Unit No. Unit No.
1-2 1-3
Unit No.
1-4
Toshiba XXXXXXX(X/X)