Publicidad
Idiomas disponibles
Idiomas disponibles
4.11. Battery test
During the measurement, the operator can check the battery charge
status. Press the C key, and check the display information. If the
charge is enough, the display will show the message "BAT OK". If the
charge is not enough, the display will show the message "LOW BAT", and
the battery should be recharged. The bargraph will give an approximate
idea of the remaining charge percentage (at least 20 % is required for a
normal operation).
If battery charge is under 20 % of the total, the message "LO BAT" will
automatically appears on the display.
4.12. Built-in printer (optional)
In order to enable the printing function press A key before start the test.
Measured values will be printed each 15 seconds, and the Dielectric
Absorption Index and Polarization Index will be printed when they
becomes ready (after 1 minute and 10 minutes respectively). Printing may
be started or stopped at any time during the test.
4.13. Auto power-off
The Auto-Power-off function turns Off the equipment consumption in two
situations:
•
During the measurement - after 35 minutes of operation, without
allowing that the battery status checking function is carried out during
that period.
•
Idle equipment - after 10 minutes of inactivity.
14
Publicidad
