Publicidad
Idiomas disponibles
Idiomas disponibles
7. Built-in printer (optional)
In order to enable the printing function press A key before start the test.
Measured values will be printed each 15 seconds, and the Dielectric
Absorption Index and Polarization Index will be printed when they
becomes ready (after 1 minute and 10 minutes respectively). Printing may
be started or stopped at any time during the test.
7.1. Printing sample
7.2. Paper feed
The key (, a blue button located at the upper-left in the printer body, is
the Paper Feed control. Press this button for 3 times after the end of the
test and before to cut the paper, in order to advance the paper sufficiently
to keep the last lines.
CAUTION: Do not pull the paper, always use the Paper Feed button. Never pull
the paper back. The printer could be easily damaged by pulling the paper in any
direction.
7.3. Paper
White side
Yellow side
This printer uses a thermal paper, 37 mm wide, in
a roll of up to 33 mm diameter. Figure below
shows how to insert the paper. Press Key ( until
paper appears. To change the paper roll please
cut the paper before it enters inside the printer,
and then press the Paper Feed button (,
because the paper movement is uni-directional.
21
Publicidad
