Publicidad
Idiomas disponibles
Idiomas disponibles
EN
6.2
HANDLING
a
Be careful when moving the appliance to avoid pos-
sible damages to it. The appliance should only be
unpacked once it has reached the installation site.
The appliance must be lifted and handled exclusive-
■
ly using suitable lifting equipment with adequate
load-bearing capacity for the weight to be lifted;
check the data of the label on the packaging.
Be careful since the appliance tends to unbalance,
■
because its centre of gravity is shifted towards the
front.
Adequately protect wooden or parquet flooring to
■
prevent it from getting damaged.
In order to prevent accidents or damages to the product, strictly ob-
serve the following recommendations:
- when shifting the packaging, perform slow and continuous move-
ments
- do not tilt the packaging too far so as to prevent the product from
tipping over
- the area where the product will be handled must be carefully
cleaned and free from any type of hindrance.
6.3
UNPACKING
a
When removing the packaging, be careful to avoid
scratching or damaging the product.
Do not disperse packaging material in the envi-
■
ronment or leave it within reach of children, as the
packaging may be potentially dangerous. It must
therefore be disposed of according to the current
legislation.
Remove from the appliance the accessories and any
■
polystyrene or cardboard parts used to secure the
moving parts.
When handling any steel parts, we suggest wearing
■
clean cotton gloves to avoid leaving fingerprints on
the product which could be difficult to remove during
cleaning.
To remove the appliance from its transport support (pallet):
- loosen the screws and remove the rear fixing bracket
- lift the appliance using equipment suited to its weight
- remove the transport support (pallet).
14
6.4
POSITIONING THE APPLIANCE
l
Before positioning the appliance, make sure that the
chosen site is suitable for the product's placement
and operation; carefully read the information and
specifications contained in the section
tion for
installation".
Once the packaging and the transport support (pallet) have been re-
moved, position the appliance in its final destination.
Use a suitable lifting device with a load-bearing capacity adequate to
the weight to be lifted and be careful not to ruin the floor; if necessary,
protect the floor with suitable material.
Once the appliance has been positioned, it must be levelled with the
aid of a spirit level by turning the adjustable feet.
6.5
CONNECTING THE COMBUSTION AIR
The appliance is standard-configured for drawing combustion air
from the same room where the product is installed, with the non-duct-
ed intake situated on the rear side.
Fig. 9
INSTALLATION
"Configura-
x4
Fig. 10
Fig. 11
CS.SB80.IST_EN_Rev. 2.0_09-23
Publicidad
