klover SOFT 80 Instrucciones Para La Instalación, El Uso Y El Mantenimiento página 53

INSTALLATION
a
We recommend carefully reading the chapter
bustion air intake" to verify that the room of instal-
lation properly matches the type of combustion air
intake system of the appliance.
l
For installing any KITS and ACCESSORIES to modify
the type of combustion air intake system, consult the
instructions attached to the same.
6.6 CONNECTION TO THE FUME EXHAUST
a
We recommend carefully reading the chapters
mum safety clearances" and
The appliance is standard-configured with the fume exhaust on the
rear (Sb)
The fume exhaust can be modified using the outlets configured and
present on the appliance:
- upper fume exhaust Su
l
For installing KITS and ACCESSORIES to modify the
type of fume exhaust, consult the instructions at-
tached to the same.
CS.SB80.IST_EN_Rev. 2.0_09-23
"Com-
"Mini-
"Flue gas channel".
Su
Sb
Fig. 12
6.6.1 CONNECTION TO THE UPPER FUME EXHAUST
To modify the configuration of the fume exhaust from rear to upper,
proceed as follows:
- loosen the screws, remove the protective panel and the rear fuel
exhaust elbow (Sb)
Sb
- remove the cap (Su) from the upper panel, taking care not to dam-
age the coating
- insert the upper fume exhaust
Su
- put the rear protective panel back on.
EN
Fig. 13
Fig. 14
15