klover SOFT 80 Instrucciones Para La Instalación, El Uso Y El Mantenimiento página 70

EN
10.7 CLEANING OF THE BRAZIER
l
Recommended cleaning frequency: consult the para-
graph "Scheduled maintenance".
Before proceeding with the cleaning operations, any
■
unburned pellets left in the brazier must be removed.
Consult the paragraph
■
the ash.
TOOLS TO BE USED; ash vacuum device equipped
■
with a fine-mesh filter in order to prevent part of the
ash from being blown into the room.
d
The unburned pellets must NOT be poured into the
tank.
To clean the brazier, proceed as follows:
- open the door of the appliance, consult the paragraph
door"
- remove the ring covering the brazier
- use a suitable suction device to remove combustion residues and
any ash deposited inside and outside of the brazier
- put the brazier covering ring back on.
32
"Ash disposal" to dispose of
"Opening the
Fig. 36
10.8 CLEANING OF THE HEAT EXCHANGER
l
Recommended cleaning frequency: consult the para-
graph "Scheduled maintenance".
TOOLS TO BE USED; hook for cleaning the front heat
■
exchanger (supplied).
To clean the heat exchanger, proceed as follows:
- use the appropriate front scraper cleaning hook (supplied) to hook
the scraper rod that cleans the heat exchanger
- move the rod forward and backwards to clean the heat exchanger
from any combustion residues
- open the door of the appliance, consult the paragraph
door"
- remove the flame separator.
l
It is advisable to proceed with the
combustion chamber" operation.
MAINTENANCE
Fig. 37
"Opening the
Fig. 38
"Cleaning of the
CS.SB80.IST_EN_Rev. 2.0_09-23