klover SOFT 80 Instrucciones Para La Instalación, El Uso Y El Mantenimiento página 56

EN
6.8.2 CONNECTING THE ROOM THERMOSTAT OR ROOM SENSOR
The table below describes the operation of the terminal blocks found on the appliance's control panel.
Description
(1)
Main room
(2)
Ducted room 1
(present only on models with one
or two ducted outlets)
(3)
Ducted room 2
(present only on models with two
ducted outputs)
(*) Connect a non-powered room thermostat to manage a simple dry contact and, preferably, with a settable hysteresis value.
(**) Connect a type "NTC 10K ± 1%" room sensor.
18
Type of control
Only with room thermostat (*)
With room thermostat (*) (it must
be enabled in Pr56 with value T1
or T1+2)
With room sensor (**) (it must
be enabled in Pr56 with value S1
or S1+2)
With room thermostat (*) (it must
be enabled in Pr56 with value T2
or T1+2)
With room sensor (**) (it must
be enabled in Pr56 with value S2
or S1+2)
Action
With the contact CLOSED, the appliance continues to work at the set
power, regardless of the SET ROOM (
of any other room thermostats or sensors connected.
With the contact OPEN, the appliance enters the modulation mode,
provided that the room temperature set in SET ROOM (
fulfilled and that any other room thermostats or sensors connected
are fulfilled.
With the contact CLOSED, the appliance continues to work at the set
power, regardless of the SET ROOM (
of any other thermostats connected.
With the contact OPEN, the appliance enters the modulation mode,
provided that the room temperature set in SET ROOM (
fulfilled and that any other thermostats connected.
The ducted room 1 fan modulates nonetheless.
When the temperature set in SET ROOM 1 (Menu 12-SET ROOM
DUCT.) is reached, the appliance enters the modulation mode,
provided that the room temperature set in SET ROOM (
fulfilled and that any other room thermostats or sensors connected
are fulfilled.
The ducted room 1 fan modulates nonetheless.
With the contact CLOSED, the appliance continues to work at the set
power, regardless of the SET ROOM (
of any other thermostats connected.
With the contact OPEN, the appliance enters the modulation mode,
provided that the room temperature set in SET ROOM (
fulfilled and that any other thermostats connected.
The ducted room 2 fan modulates nonetheless.
When the temperature set in SET ROOM 2 (Menu 12-SET ROOM
DUCT.) is reached, the appliance enters the modulation mode,
provided that the room temperature set in SET ROOM (
fulfilled and that any other room thermostats or sensors connected
are fulfilled.
The ducted room 2 fan modulates nonetheless.
INSTALLATION
button) value and the status
+
button) is
+
button) value and the status
+
button) is
+
button) is
+
button) value and the status
+
button) is
+
button) is
+
CS.SB80.IST_EN_Rev. 2.0_09-23